Command Reference SNTP Commands
SNTP is disabled by default.
Global configuration mode.
The following example enables SNTP.
Ruijie(config)# sntp enable
Displays the SNTP configuration.
Use this command to set the interval for the SNTP client to synchronize its clock with the NTP/SNTP
server. Use the no form of this command to restore the default synchronization interval.
Synchronization interval. The unit is second, and the range is from 60 to 65,535.
The default synchronization interval is 1,800 seconds.
Global configuration mode.
To make the synchronization interval configuration effective, run the sntp enable command.
The following example configures the synchronization interval to 3,600 seconds.
Ruijie(config)# sntp interval 3600
Displays the SNTP configuration.
To Next Page
Loading...
Need help?
General