Command Reference SPAN-RSPAN Commands
Use this command to configure the SPAN session and specify the source port (monitored port).
monitor session session-num source interface interface-id [ both | rx | tx ]
Use this command to configure the SPAN session mirroring only the traffic permitted by the access
list
monitor session session-num source interface interface-id rx acl acl-name
Use this command to configure the SPAN session and specify the destination port (monitoring port).
monitor session session-num destination interface interface-id [switch ]
Use this command to configure the remote SPAN session ID on the source device..
monitor session session-num remote-source
Use this command to configure the remote SPAN session ID on the destination device.
monitor session session-num remote-destination
Use this command to configure the remote SPAN session and specify the remote SPAN destination
VLAN.
monitor session session-num destination remote vlan remote-vlan-id interface interface-id
[ switch ]
Use this command to configure the SPAN session and specify the source VLAN to monitor. Note that
the source VLAN should not be a remote VLAN.
monitor session session-num source vlan vlan-id [ rx | tx | both ]
Use this command to limit the SPAN source traffic to specific VLANs.
monitor session session-num filter vlan vlan-id-list
Use this command to remove the specified SPAN session, or remove the source port or destination
port of the specified SPAN session.
no monitor session session-num [ source interface interface-id | destination interface
interface-id ]
Use this command to remove the specified remote SPAN session, or remove the destination port of
To Next Page
Loading...
