Ruijie RG-S29 Series User Manual

Command Reference sFlow Commands
Messages
invalid host address.
Common
Errors
N/A
Platforms
N/A
7.2 sflow collector collector-id destination
Use this command to configure the address of the sFlow Collector.
sflow collector collector-id destination { ip-address | ipv6 ipv6_address } udp-port ]
Use this command to delete the address of the sFlow Collector.
no sflow collector collector-id destination { ip-address | ipv6 ipv6_address } udp-port ]
Use this command to delete the address of the sFlow Collector.
default sflow collector collector-id destination { ip-address | ipv6 ipv6_address } udp-port ]
Parameter
Description
Parameter
Description
collector-id
sFlow Collector ID. The range is from 1 to 2.
ip-address
sFlow Collector IPv4 address
ipv6 ipv6-address
sFlow Collector IPv6 address
udp-port
sFlow Collector listening port number
Defaults
Command
Mode
Global configuration mode
Default Level
14
Usage Guide
This command is used to configure the sFlow Collector address. The sFlow Collector address shall be a
host address. When a non-host address (for example, a multicast or broadcast address) is configured
as the sFlow Collector address, a message indicating configuration failure is displayed. The sFlow
Collector monitors the sFlow datagram on the specified port.
Configuration
Examples
N/A
Verification
Use the show sflow command to display the sFlow Collector.
Prompt
Messages
Prompt an error message when the address is invalid.
invalid host address.

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English