Ruijie RG-S29 Series

Command Reference sFlow Commands
Common
Errors
N/A
Platforms
N/A
7.4 sflow counter collector
Use this command to enable the sFlow Agent to send counter samples to the sFlow Collector.
sflow counter collector collector-id
Use this command to disable the sFlow Agent to send counter samples to the sFlow Collector.
no sflow counter collector
Use this command to disable the sFlow Agent to send counter samples to the sFlow Collector.
default sflow counter collector
Parameter
Description
Parameter
Description
collector-id
sFlow Collector ID. The range is from 1 to 2.
Defaults
Command
Mode
Interface configuration mode
Default Level
14
Usage Guide
This command can be used for physical ports, SVI ports and sub routed ports and aggregate ports.
sFlow datagrams can be output only when an IP address is configured for the corresponding sFlow
Collector.
Configuration
Examples
The following example enables interface TenGigabitEthernet 0/5 to send counter samples to sFlow
Collector 2.
Ruijie(config-if-TenGigabitEthernet 0/5)# sflow counter collector 2
Verification
Use the show sflow command to display the sFlow counter sampling configuration.
Prompt
Messages
N/A
Common
Errors
N/A
Platforms
N/A