Command Reference Syslog Commands
logging count
no logging count
The log statistics function is disabled by default.
Global configuration mode
This command enables the log statistics function. The statistics begins when the function is enabled.
If you run the no logging count command, the statistics function is disabled and the statistics data is
deleted.
The following example enables the log statistics function:
Ruijie(config)# logging count
Displays log information about modules of the system.
Displays basic configuration of log modules and log
information in the buffer.
8.6 logging delay-send file
Use this command to set the name of the log file saved locally for delay sending. Use the no form of
this command to restore the default setting.
logging delay-send file flash:filename
no logging delay-send file
Sets the name of the log file saved locally for delay sending.
The default name format is as follows: file size_device IP address_index.txt. If you want to change the
file name, the file sent to the remote server should be named as follows: prefix_ file size_device IP
address_index.txt; the file saved locally should be named as follows: prefix_index.txt. The default
prefix is syslog_ftp_server.
To Next Page
Loading...
Need help?
General