Ruijie RG-S29 Series

Command Reference Module Hot-plugging/ unplugging Commands
12 Module Hot-plugging/ unplugging Commands
12.1 remove configure device device-id
Use this command to remove the configuration on a VSU device, which validates in VSU mode after
restart.
remove configure device device-id
Parameter
Description
Parameter
Description
device-id
The chassis number.
Defaults
N/A
Command
Mode
Global configuration mode
Usage Guide
This command is used to remove the configuration on a VSU device. It validates after the device is
restarted.
Configuration
Examples
The following example clears the configuration on device 1.
Ruijie(config)# remove configure device 1
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
12.2 show manuinfo
Use this command to display asset information about all independent components in the system for
asset management, including the chassis, fan, power, management board, and line card. The
information covers the ID, slot number, name, serial number (SN), software and hardware version,
and MAC address. Not all devices support display of the same information and only supported
information is printed.
show manuinfo
Parameter
Description
Parameter
Description