Ruijie RG-S29 Series User Manual

Command Reference Module Hot-plugging/ unplugging Commands
12.6 sysmac
Use this command to configure a MAC address for the system. Use the no form of this command to
remove the setting.
Sysmac mac-address
no sysmac
Parameter
Description
Parameter
Description
mac-address
Configures a MAC address for the system.
Defaults
N/A
Command
Mode
Global configuration mode
Usage Guide
1. In general, the MAC address is programmed on the management board or the chassis flash. In
virtual switching unit (VSU) mode, the system saves the MAC address in use in the configuration
file to avoid flow interruption caused by MAC address change. The valid MAC address saved in
the configuration file validates in preference after the device is restarted,
2. The MAC address of the gateway may be bound on some downstream devices. If the system is
configured with the auth-mode gateway command, you can use the sysmac command to
replace the MAC address of the gateway without changing the MAC address configuration on the
downstream devices.
3. The configuration takes effect after the device is restarted.
Configuration
Examples
The following example deletes the MAC address saved in the configuration file.
Ruijie#no sysmac
The following example configures MAC address 00d0.f822.33e2 for the system.
Ruijie#sysmac 00d0.f822.33e2
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English