Ruijie RG-S29 Series User Manual

Command Reference Supervisor Module Redundancy Commands
Mode
Usage Guide
Resetting the supervisor module does not affect data forwarding. Data forwarding will not be
interrupted and the user session information will not be missing.
The redundancy reload shelf command is used to reset the device which works as a single physical
device. The redundancy reload shelf switchid command is used to reset the specified device which
works as a VSU device.
Configuration
Examples
The following example resets the standby supervisor module.
Ruijie# redundancy reload peer
This operation will reload the current slave unit. Are you sure to continue?
[N/y] y
Preparing to reload peer!
The following example resets device 2 which works as a VSU device.
Ruijie# redundancy reload shelf 2
This operation will reload the device 2. Are you sure to continue? [N/y] y
Preparing to reload device 2!
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
13.5 show redundancy states
Use this command to display the current redundancy state.
show redundancy states
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
N/A
Command
Mode
User EXEC mode / Privileged EXEC mode
Usage Guide
Currently, only 1:1 hot backup (for the global active module and standby module) is supported in the
VSU mode. Therefore, only the hot backup state of the local and peer device is displayed.
Configuration
The following example displays the redundancy states of active supervisor module.

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English