Ruijie RG-S29 Series

Command Reference PoE Management Commands
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
14.4 poe max-power
Use this command to set the maximum power for the port. Use the no or default form of this
command to restore the default setting,
poe max-power int
no poe max-power
default poe max-power
Parameter
Description
Parameter
Description
int
The maximum power, in the range from 0 to 30W.
Note that this parameter is in the range from 0 to 15.4W on the
system supporting 802.3af only. HPoE port ID is in the range from 0
to 90.
Defaults
The maximum power is not set by default.
Command
Mode
Interface configuration mode
Usage Guide
N/A.
Configuration
Examples
The following example sets the maximum power for port GigabitEthernet 0/1 to 20W.
Ruijie(config)# interface GigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# poe max-power 20
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A