Ruijie RG-S29 Series

Command Reference Interface Commands
snmp trap link-status
no snmp trap link-status
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is enabled by default
Command
Mode
Interface configuration mode.
Usage Guide
For an interface (for instance, Ethernet interface, AP interface, and SVI interface), this command sets
whether to send LinkTrap on the interface. If the function is enabled, the SNMP sends the LinkTrap
when the link status of the interface changes.
Configuration
Examples
The following example disables the interface from sending LinkTrap on the interface.
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if)# no snmp trap link-status
The following example enables the interface to forward Link trap.
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if)# snmp trap link-status
Related
Commands
Command
Description
snmp trap link-status
Enables the interface to send LinkTrap on the
interface.
no snmp trap link-status
Disables the interface from sending LinkTrap
on the interface.
Platform
Description
N/A
1.31 snmp-server if-index persist
Use this command to set the interface index persistence. The interface index remains the same after
the device is restarted.
snmp-server if-index persist
Parameter
Description
Parameter
Description
N/A
N/A