Command Reference Private VLAN Commands
The following example displays the private VLAN configuration.
Ruijie# show vlan private-vlan
VLAN Type Status Routed Ports Associated VLANs
----- ---------- -------- -------- ------------------------------ ------------------
30 primary inactive Enabled
31 isolated inactive Disabled No Association
90 primary active Disabled 91-92
91 isolated active Disabled 90
92 community active Disabled Gi0/1 90
7.6 switchport mode private-vlan
Use this command to declare the private VLAN mode of the interface. Use the no or default form of
this command to restore the default setting.
switchport mode private-vlan { host | promiscuous }
Host mode of the private VLAN
Promiscuous mode of the private VLAN
The port is an access port by default.
Interface configuration mode.
Before a port is configured as an isolated port or promiscuous port, and the port mode must be
To Next Page
Loading...
Need help?
General