Command Reference GVRP Commands
This function is disabled by default.
Global configuration mode
This command is used to display the configuration.
The following example enables the GVRP function.
Ruijie(config)#gvrp enable
Displays the GVRP configurations.
10.6 gvrp registration mode
Use this command to set the registration mode to control whether to enable dynamic VLAN
creation/registration/canceling on the port. Use the no form of this command to restore the default
setting.
gvrp registration mode { normal | disabled }
no gvrp registration mode
Enables dynamic VLAN creation/registration/canceling on the port.
Disables dynamic VLAN creation/registration/canceling on the port.
Dynamic VLAN creation/registration/canceling is enabled by default,
Interface configuration mode.
The following example sets the registration mode.
Ruijie(config-if)# gvrp registration mode normal
To Next Page
Loading...
Need help?
General