Command Reference LLDP Commands
trusted DSCP mode.)
3. If 802.1X authentication is enabled on the port at the same time, a security channel needs to be
configured to transmit packets from the voice VLAN.
If the IP phone does not support LLDP-MED, the voice VLAN function must be enabled. In addition,
the MAC address of the IP phone needs to be added to the voice VLAN OUI list manually.
For details about how to configure the QoS trusted mode, see chapter "IP QoS." For details about
how to configure the voice VLAN, see chapter "Voice VLAN." For details about how to configure the
security channel, see chapter "ACL."
The following example configures the LLDP network policy (profile-num is 1).
Ruijie#config
Ruijie(config)#lldp network-policy profile 1
Ruijie(config-lldp-network-policy)# voice vlan untagged
Ruijie(config-lldp-network-policy)# voice-signaling vlan 3 cos 4
Ruijie(config-lldp-network-policy)# voice-signaling vlan 3 dscp 6
show lldp network-policy profile [ profile-num ]
Displays the LLDP network policy.
Use this command to configure a common LLDP address. Use the no form of this command to delete
the address.
civic-location { country | state | county | city | division | neighborhood | street-group |
leading-street-dir | trailing-street-suffix | street-suffix | number | street-number-suffix |
landmark | additional-location-information | name | postal-code | building | unit | floor | room |
type-of-place | postal-community-name | post-office-box | additional-code } ca-word
no civic-location { country | state | county | city | division | neighborhood | street-group |
leading-street-dir | trailing-street-suffix | street-suffix | number | street-number-suffix |
landmark | additional-location-information | name | postal-code | building | unit | floor | room |
type-of-place | postal-community-name | post-office-box | additional-code } ca-word
Country code, two bytes. For example, the country code of
China is CH.
Address information, CA type 1
To Next Page
Loading...
