Command Reference LLDP Commands
This command is used to configure the device type in a common LLDP address in LLDP Civic
address configuration mode.
The following example sets the device type to switch.
Ruijie#config
Ruijie(config)# lldp location civic-location identifier 1
Ruijie(config-lldp-civic)# device-type 1
show lldp location civic-location { identifier id
| interface interface-name | static }
Displays LLDP Civic Address information.
11.6 lldp compliance vendor
Use this command to enable detection of compatible neighbors.
no lldp compliance vendor
This function is disabled by default.
Global configuration mode
The following example enables detection of compatible neighbors.
Ruijie#configure terminal
Ruijie(config)# lldp compliance vendor
To Next Page
Loading...
Need help?
General