Ruijie RG-S29 Series

Command Reference QinQ Commands
add
Add allowed VLAN.
tagged
Tag-carried.
untagged
Not tag-carried.
v_list
vlan id list.
no
Remove the settings.
Defaults
The default is untagged 1.
Command
Mode
Interface configuration mode.
Usage Guide
N/A
Configuration
Examples
The following example specifies vlan 3-6 of dot1q-tunnel port as allowed VLAN and outputting the
frame with tag.
Ruijie(config)#interface gigabitEthernet 0/1
Ruijie(config-if)#switchport dot1q-tunnel allowed vlan tagged 3-6
Ruijie(config)#end
Related
Commands
Command
Description
show interface dot1q-tunnel
N/A
Platform
Description
N/A
12.24 switchport dot1q-tunnel native vlan
Use this command to configure the default vlan id of dot1q-tunnel. Use the no or default form of this
command to restore the default setting.
switchport dot1q-tunnel native vlan vid
no switchport dot1q-tunnel native vlan
default switchport dot1q-tunnel native vlan
Parameter
Description
Parameter
Description
vid
Configures default vlan id.
Defaults
The default is VLAN 1.
Command
Mode
Interface configuration mode.