Ruijie RG-S29 Series

Command Reference QinQ Commands
12.27 traffic-redirect access-group acl nested-vlan vid in
Use this command to configure vid add policy list based on flow on dot1q-tunne port. Use the no or
default form of this command to restore the default setting.
traffic-redirect access-group acl nested-vlan vid in
no traffic-redirect access-group acl nested –vlan
default traffic-redirect access-group acl nested -vlan
Parameter
Description
Parameter
Description
acl
Flow matching.
vid
vid list to be added.
Defaults
The policy list is null by default.
Command
Mode
Interface configuration mode.
Usage Guide
N/A
Configuration
Examples
The following example specifies the vid of input message whose source address is 1.1.1.3 as 9.
Ruijie#configure
Ruijie(config)#ip access-list standard 20
Ruijie(config-std-nacl)#permit host 1.1.1.3
Ruijie(config-std-nacl)#exit
Ruijie(config)# interface gigabitEthernet 0/1
Ruijie(config-if)# switchport mode dot1q-tunnel
Ruijie(config-if)# traffic-redirect access-group 20 nested-vlan 10 in
Ruijie(config-if)# end
Related
Commands
Command
Description
show traffic-redirect
N/A
Platform
Description
N/A
12.28 traffic-redirect access-group acl outer-vlan vid in
Use this command to configure the modify policy list of outer vid based on flow on access, trunk,
hybrid port. Use the no or default form of this command to restore the default setting.
traffic-redirect access-group acl outer-vlan vid in
no traffic-redirect access-group acl outer-vlan