Ruijie RG-S29 Series

Command Reference ARP Commands
local-proxy-arp
no local-proxy-arp
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
N/A
Command
Mode
Interface configuration mode
Usage Guide
With local proxy ARP enabled, the device helps a host to obtain MAC addresses of other hosts on
the subnet. If the device enables switchport protected, users on different ports are segregated on
layer 2. After local proxy ARP is enabled, the device serves as a proxy to send a response after
receiving an ARP request. The ARP response contains a MAC address which is the device’s
Ethernet MAC address, realizing communication between different hosts through L3 routes.
Configuration
Examples
The following example enables local proxy ARP on VLAN1.
Ruijie(config)# interface vlan 1
Ruijie(config-if-VLAN 1)# local-proxy-arp
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
2.16 service trustedarp
Use this command to enable the trusted ARP function. Use the no form of this command to restore
the default setting.
service trustedarp
no service trustedarp
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is disabled by default.
Command
Mode
Global configuration mode
Usage Guide
The trusted ARP function of the device is to prevent the ARP fraud function. As a part of the GSN