Command Reference IPv6 Commands
Displays the interface information.
Sets the lifetime of the device.
Sets the hopfcount of the RA message.
Sets the MTU of the RA message.
Use this command to set the device lifetime of the RA sent on the interface. Use the no form of this
command to restore the default setting.
ipv6 nd ra-lifetime seconds
Default life time of the device on the interface, in the range
from 0 to 9000 in the unit of seconds.
Interface configuration mode.
The router lifetime field is available in each RA. It specifies the time during which the hosts along the
link of the interface can select the device as the default device. If the value is set to 0, the device will
not serve as the default device any longer. If it is not set to 0, it shall be larger than or equal to the
interval of sending the RA (ra-interval)
Ruijie(conifig-if)# ipv6 nd ra-lifetime 2000
Displays the interface information.
Sets the interval of sending the RA.
Sets the hopcount of the RA.
To Next Page
Loading...
Need help?
General