Command Reference IPv6 Commands
Use this command to disable the interface from sending the RA message. Use the no form of
this command to enable the function.
The ipv6 nd suppress-ra command is enabled by default.
Interface configuration mode.
This command suppresses the sending of the RA message on an interface.
Ruijie(config-if)# ipv6 nd suppress-ra
Displays the interface information.
Use this command to set the maximum number of the unresolved neighbor table entries. Use the no
form of this command to restore the default setting.
ipv6 nd unresolved number
Sets the maximum number of the unresolved neighbor
table entries, in the range from 1 to the neighbor table
size supported by the device.
To Next Page
Loading...
