Command Reference Line Commands
escape-character escape-value
Sets the ASCII value corresponding to the escape character for the
line, in the range from 0 to 255.
The default escape character is Ctrl+^ (Ctrl+Shift+6) and the ASCII decimal value is 30.
After configuring this command, press the key combination of the escape character and then press x,
the current session is disconnected to return to the original session.
The following example sets the escape character for the line to 23 (Ctrl+w).
Ruijie(config)# line vty 0
Ruijie(config-line)# escape-character 23
Use this command to enable the line to enter the command line interface. Use the no form of this
command to disable the function.
This function is enabled by default.
The no exec command is used to ban the line from entering the command line interface. You have to
To Next Page
Loading...
