Ruijie RG-S29 Series

Command Reference RIP Commands
Ruijie (config-router)# no auto-summary
Related
Commands
Command
Description
auto-summary
Enables the automatic convergence of RIP
routes.
Platform
Description
N/A
1.20 ip rip triggered
Use this command to enable triggered RIP based on links. Use the no form of this command to
restore the default setting.
ip rip triggered
ip rip triggered retransmit-timer timer
ip rip triggered retransmit-count count
no ip rip triggered
no ip rip triggered retransmit-timer
no ip rip triggered retransmit-count
Parameter
Description
Parameter
Description
retransmit-timer timer
Configures the interval at which the Update Request and Update
Response packets are retransmitted. The range is from 1 to 3,600.
The unit is second. The default is five.
retransmit-count count
Configures the maximum times that the Update Request and Update
Response packets are retransmitted. The range is from 1 to 3600.
The default is 36.
Defaults
This function is disabled by default.
Command
Mode
Interface configuration mode
Usage Guide
Triggered RIP (TRIP) is the extension of RIP on the wide area network (WAN), mainly used for
demand-based links.
With the TRIP function enabled, RIP no longer sends route updates periodically and sends route
updates to the WAN interface only if:
 Update Request packets are received.
 RIP routing information is changed.
 Interface state is changed.