Ruijie RG-S29 Series

Command Reference RIP Commands
of this command to restore the default setting.
ip rip v2-broadcast
no ip rip v2-broadcast
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
The default behavior depends on the configuration of the version command.
Command
Mode
Interface configuration mode
Usage Guide
This command overwrites the default of the version command. This command affects only sending
RIP packets on the interface. This command allows RIPv1 and RIPv2 packages sent on the interface
simultaneously. If this command is configured without parameters, package receiving depends on the
version setting.
Configuration
Examples
The following example sends RIPv2 packets in broadcast mode on the fastEthernet 0/1 interface.
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if-FastEthernet 0/1)# no ip rip split-horizon
Related
Commands
Command
Description
version
Defines the default version of the RIP packets
received and sent on the interface.
Platform
Description
N/A
1.22 neighbor
Use this command to define the IP address of a RIP neighbor. Use the no form of this command to
restore the default setting.
neighbor ip-address
no neighbor ip-address
Parameter
Description
Parameter
Description
ip-address
Indicates the IP address of the neighbor. The IP address must be that
of the network connected to the local device.
Defaults
The neighbor is not defined by default.