EasyManua.ls Logo

Ruijie RG-S29 Series

Ruijie RG-S29 Series
1510 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Command Reference OSPFv2 Commands
no two-way-maintain
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is enabled by default.
Command
Mode
Routing process configuration mode
Usage Guide
In the large-scale network, partial packets delay or dropped may exist due to much CPU and memory
are occupied caused by lots of packet transmission. If the Hello packets are handled over
dead-interval, the corresponding adjacency will be disconnected. In this case, you can enable the
two-way-maintain function for the packets such as DD, LSU, LSR and LSAck packets from a neighbor
in the network (except for the Hello packets), avoiding the neighbor invalidation caused by delayed or
dropped Hello packets.
Configuration
Examples
The following example disables the OSPF two-way-maintain function.
Ruijie(config)# routerospf1
Ruijie(config-router)# notwo-way-maintain
Related
Commands
Command
Description
show ip ospf
Displays the configuration information of the
OSPF
Platform
Description
N/A

Table of Contents

Related product manuals