Ruijie RG-S29 Series

Command Reference OSPFv3 Commands
Description
Error
Configures all error-related trap types. This keyword can also
specify the following types of error traps:
IfConfigError
Specifies an interface parameter error;
IfRxBadPacket
Specifies incorrect packets received by an
interface;
VirtIfConfigError
Specifies a parameter error on a virtual
interface;
VirtIfRxBadPacket
Specifies incorrect packets received by a
virtual interface.
state-change
Configures all traps related to state change. This keyword can also
specify the following traps related to state change:
IfStateChange
Specifies state change of an
interface;
NbrStateChange
Specifies state change of a
neighbor;
NssaTranslatorStatusChange
Specifies status change of the
NSSA translator.
VirtIfStateChange
Specifies state change of a
virtual interface;
VirtNbrStateChange
Specifies state change of a
virtual neighbor.
Defaults
All traps are disabled by default.
Command
Mode
Routing process configuration mode
Usage Guide
Before configuring this command, you must run the snmp-server enable traps ospf command;
otherwise, OSPFv3 trap information cannot be sent correctly. This is because the function of this
command is restricted by the snmp-server command.
You can synchronously enable the trap function of different processes even if MIB is not bound to
these processes.
Configuration
Examples
The following example enables all traps of OSPFv3 process 100.
Ruijie(config)#ipv6 router ospf 100
Ruijie(config-router)# enable traps
Related
Commands
Command
Description
show ipv6 ospf
Displays global OSPFv3 configuration
information.
enable mib-binding
Binds MIB to an OSPFv3 process.
snmp-server enable traps ospf
Enables OSPFv3 to send trap information.