Command Reference OSPFv3 Commands
Indicates that encryption authentication is not performed.
Specifies a security parameter index, in the range from 256 to
4294967295.
Specifies the null encryption mode.
Specifies the MD5 authentication mode.
Specifies the SHA1 authentication mode.
Indicates that a key is displayed in the plain-text format.
Indicates that a key is displayed in the cipher-text format.
Specifies an authentication key.
Encryption authentication is not performed by default.
Interface configuration mode
RGOS supports the null encryption mode and two authentication modes: MD5 and SHA1.
OSPFv3 encryption authentication parameters configured on interconnected interfaces must be
consistent.
The following example specifies null encryption and MD5 authentication in OSPFv3 interface
configuration mode and sets the authentication password to aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa.
Ruijie(config-if)# ipv6 ospf encryption ipsec spi 300 esp null md5
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Specifies area encryption authentication.
area virtual-link encryption
Specifies virtual link encryption authentication.
3.23 ipv6 ospf hello-interval
Use this command to set the interval for the interface to send the Hello message. Use the no form of
this command to restore the default setting
ipv6 ospf hello-interval seconds [ instance instance-id ]
no ipv6 ospf hello-interval [ instance instance-id ]
To Next Page
Loading...
Need help?
General