Command Reference OSPFv3 Commands
overwritten each other.
With neither timers spf command nor timers throttle spf command configured, the default
value refers to the default of the timers throttle spf command
The following example configures the delay and holdtime and the maximum time interval of the
OSPFv3 as 5ms, 1000ms and 90000ms respectively. If the topology changes consecutively, the time
for SPF calculation is: five milliseconds, one second, three seconds, seven seconds, 15 seconds, 31
seconds, 63 seconds, 89 seconds, 179 seconds, 179+90 seconds……
Ruijie(config)# ipv6 router ospf 20
Ruijie(config-router)# timers spf 5 1000 90000
Restarts part of the OSPFv3 function.
Displays the routing process information of the
OSFPv3
Configures the SPF calculation delay .
Use this command to enable two-way OSPFv3 maintenance. Use the no form of this command to
disable this function.
Two-way OSPFv3 maintenance is enabled by default.
Routing process configuration mode
Sometimes, there are a lot of sent and received packets on a network, occupying large CPU and
memory resources. As a result, some packets cannot be processed immediately or are directly lost. If
hello packets from a neighbor cannot be processed within the dead interval of neighbors, the
connection with the neighbor will be interrupted due to connection timeout. If two-way OSPFv3
maintenance is enabled and a large number of packets exist on the network, besides hello packets,
the two-way neighboring relationship between the device and the neighbor can also be maintained by
To Next Page
Loading...
Need help?
General