Command Reference Protocol-independent Configuration Commands
Privileged EXEC mode, global configuration mode, interface configuration mode, routing protocol
configuration mode, and routing map configuration mode
Information about the status of only the currently running routing protocol is displayed, and the
information about a routing protocol that is not running is not displayed.
6.46 show ipv6 prefix-list
Use this command to display the information about the IPv6 prefix list or its entries.
show ipv6 prefix-list [prefix-name]
Name of the IPv6 prefix list.
The configuration information of all the IPv6 prefix lists is displayed.
Privileged EXEC mode, global configuration mode, interface configuration mode, route protocol
configuration mode, route map configuration mode
If no prefix list is specified, the configurations of all the prefix lists are displayed, otherwise only the
configuration of the specified prefix list is displayed.
Ruijie# show ipv6 prefix-list
ipv6 prefix-list p6: 2 entries
seq 5 permit 13::/20
seq 10 permit 14::/20
Use this command to display the key chain configuration.
show key chain [key-chain-name]
(Optional) Display the configuration of the specified key chain.
The configuration information of all key chains is displayed.
To Next Page
Loading...
Need help?
General