Command Reference IPv4 Multicast Routing Commands
Multicast Switching Cache Table
(192.168.195.23, 233.3.3.3, 1), SYNC, MTU:0, 1 OIFs
VLAN 1(0): 1 OPORTs, REQ: DONE
OPORT 6, IGMP-SNP, REQ: DONE
The fields in the execution of the show mrf mfc command are described in the following table.
Source address of the entry.
Group address of the entry.
Vlan id where the incoming interface of the entry is.
The entry has been synchronized to the hardware.
Layer-3 outgoing interface number.
The vlan where the layer-3 outgoing interface oif is.
The number of layer-2 port in the layer-3 outgoing oif.
This oif configuration on the hardware has done.
The layer-2 port in the oif with index 6.
This port is created by the IGMP SNOOPING protocol. This
value can also be the PIM-SNP, which means this port is
created by the PIM SNOOPING protocol. And the ROUTER
means this port is created by the layer-3 protocol.
The port configuration on the hardware has done.
Use this command to show the configuration of continuous multicast forwarding.
show msf nsf
Privileged EXEC mode/Global configuration mode/Interface EXEC mode
The following example shows the configuration of continuous multicast forwarding.
Ruijie# show msf nsf
Multicast HA Parameters
---------------------------------------------------+------+
protocol convergence timeout 120 secs
flow leak interval 20 secs
Ruijie#
To Next Page
Loading...
Need help?
General