Ruijie RG-S29 Series

Configuration Guide RADIUS Commands
Use the no form of this command to delete the source IP address for the RADIUS packet.
ip radius source-interface interface-name
no radius source-interface interface-name
Parameter
Description
Parameter
Description
interface-name
Interface that the source IP address of the RADIUS packet belongs
to.
Defaults
The source IP address of the RADIUS packet is set by the network layer.
Command
mode
Global configuration mode
Usage Guide
In order to reduce the NAS information to be maintained on the RADIUS server, use this command to
set the source IP address of the RADIUS packet. This command uses the first IP address of the
specified interface as the source IP address of the RADIUS packet. This command is used in the
layer 3 devices.
Configuration
Examples
The following example specifies that the RADIUS packet obtains an IP address from the fastEthernet
0/0 interface and uses it as the source IP address of the RADIUS packet.
Ruijie(config)# ip radius source-interface fastEthernet 0/0
Related
Commands
Command
Description
radius-server host
Defines the RADIUS server.
ip address
Configures the IP address of the interface.
Platform
Description
N/A
2.3 radius attribute
Use this command to set the private attribute type value.
Use the no form of this command to restore the default setting.
radius attribute { id | down-rate-limit | dscp | mac-limit |
up-rate-limit } vendor-type type
no radius attribute { id | down-rate-limit | dscp | mac-limit |
up-rate-limit } vendor-type
Parameter
Description
Parameter
Description
id
Function ID, in the range from 1 to 255
type
Private attribute type, in the range from 1