Ruijie RG-S29 Series

Configuration Guide RADIUS Commands
Usage Guide
The source port is random by default. This command is used to specify a source port.
Configuration
Examples
The following example configures source port 10000 to send RADIUS packets.
Ruijie(config)# radius-server source-port 10000
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
2.20 radius-server timeout
Use this command to set the time for the device to wait for a response from the security server after
retransmitting the RADIUS packet.
Use the no form of this command to restore the default setting.
radius-server timeout seconds
no radius-server timeout
Parameter
Description
Parameter
Description
seconds
Timeout in the range from 1 to 1,000 in the unit of seconds.
Defaults
The default is 5 seconds.
Command
Mode
Global configuration mode
Usage Guide
This command is used to change the timeout of packet retransmission.
Configuration
Examples
The following example sets the timeout to 10 seconds.
Ruijie(config)# radius-server timeout 10
Related
Commands
Command
Description
radius-server host
Defines the RADIUS security server.
radius-server retransmit
Defines the number of the RADIUS packet
retransmissions.
radius-server key
Defines a shared password for the RADIUS
server.
Platform
N/A