Siemens SINUMERIK Series Function Manual

Contents
Extended Functions
14 Function Manual, 03/2013, 6FC5397-1BP40-3BA1
6.6.3 Examples of ambiguities of position.......................................................................................... 403
6.6.4 Example of ambiguity in rotary axis position............................................................................. 404
6.6.5
PTP/CP switchover in JOG mode............................................................................................. 404
6.7
Cartesian manual travel (optional) ............................................................................................ 405
6.8
Activating transformation machine data via part program/softkey............................................ 412
6.8.1
Functionality .............................................................................................................................. 412
6.8.2
Constraints ................................................................................................................................ 413
6.8.3
Control response to power ON, mode change, RESET, block search, REPOS ...................... 415
6.8.4
List of machine data affected .................................................................................................... 415
6.9
Constraints ................................................................................................................................ 418
6.9.1
Chained transformations........................................................................................................... 418
6.10
Examples................................................................................................................................... 419
6.10.1
TRANSMIT................................................................................................................................ 419
6.10.2
TRACYL .................................................................................................................................... 420
6.10.3
TRAANG ................................................................................................................................... 426
6.10.4
Chained transformations........................................................................................................... 427
6.10.5
Activating transformation MD via a part program...................................................................... 431
6.10.6
Axis positions in the transformation chain................................................................................. 432
6.11
Data lists.................................................................................................................................... 435
6.11.1
Machine data............................................................................................................................. 435
6.11.1.1
TRANSMIT................................................................................................................................ 435
6.11.1.2
TRACYL .................................................................................................................................... 436
6.11.1.3
TRAANG ................................................................................................................................... 438
6.11.1.4
Chained transformations........................................................................................................... 439
6.11.1.5
Non transformation-specific machine data................................................................................ 439
6.11.2
Signals....................................................................................................................................... 439
6.11.2.1
Signals from channel................................................................................................................. 439
7
M5: Measurement.................................................................................................................................. 441
7.1
Brief description ........................................................................................................................ 441
7.2
Hardware requirements............................................................................................................. 442
7.2.1
Probes that can be used ........................................................................................................... 442
7.3
Channel-specific measuring...................................................................................................... 444
7.3.1
Measurement ............................................................................................................................ 444
7.3.2
Measurement results................................................................................................................. 445
7.4
Axial measurement ................................................................................................................... 446
7.4.1
Measurement ............................................................................................................................ 446
7.4.2
Telegram selection.................................................................................................................... 449
7.4.3
Measurement results................................................................................................................. 449
7.5
Setting zeros, workpiece measuring and tool measuring ......................................................... 451
7.5.1
Preset actual value memory and scratching............................................................................. 451
7.5.2
Workpiece measuring ............................................................................................................... 452
7.5.2.1
Input values............................................................................................................................... 452
7.5.2.2
Measurement selection............................................................................................................. 459
7.5.2.3
Output values ............................................................................................................................ 460
7.5.2.4
Calculation method ................................................................................................................... 461
7.5.2.5
Units of measurement and measurement variables for the calculation.................................... 464
7.5.2.6
Diagnostics................................................................................................................................ 465

Siemens SINUMERIK Series Specifications

General

Axes Control	Up to 31 axes
Category	Control Unit
Manufacturer	Siemens
Series	SINUMERIK
Control Type	CNC
Communication Interfaces	Ethernet, USB
Operating Temperature	0°C to 45°C
Protection Class	IP20
Power Supply	24V DC
Display	Color TFT LCD