Siemens SINUMERIK Series Function Manual

K5: Mode groups, channels, axis interchange
5.4 Axis/spindle replacement
Extended Functions
330 Function Manual, 03/2013, 6FC5397-1BP40-3BA1




7LPH
$IWHUSRZHU21 
3/& !1&.'%%1&. !3/&'%%
*(7.
5(/($6(.

Figure 5-6 Changing an axis from K1 to K2 via parts program
TYPE input

1&D[LVLVWRJRLQFKDQQHOV
1&UHDFWVWRULVLQJHGJH
3/&5HTXHVWQHZW\SH
$[LVLVWREHFRPH3/&D[LV
3/& !1&.'%'%%
%LW %LW
In principle, the PLC must set the signal "Request new type". It is deleted again after
change. Also for a channel interchange with GET and RELEASE (only 840D sl).
Controlling PLC axes/spindles for 840D sl
PLC axes and PLC spindles are traversed using function block FC18 in the basic PLC
program
FC18: SpinCtrl Spindle control

Siemens SINUMERIK Series Specifications

General

Axes Control	Up to 31 axes
Category	Control Unit
Manufacturer	Siemens
Series	SINUMERIK
Control Type	CNC
Communication Interfaces	Ethernet, USB
Operating Temperature	0°C to 45°C
Protection Class	IP20
Power Supply	24V DC
Display	Color TFT LCD