Siemens SINUMERIK Series

W4: Grinding-specific tool offset and tool monitoring
17.1 Tool offset for grinding operations
Extended Functions
804 Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Tool parameter Meaning Comment
Wear tool radius compensation
15 Radius 1
16 Reserved
17 Reserved
18 Reserved
19 Reserved
20 Reserved
Tool base dimension / adapter dimension tool length compensation
21 Basic length 1
22 Basic length 2
23 Basic length 3
Technology
24 Undercut angle For turning tools only
25 Reserved
:LWKZLWKRXWPRQLWRU
LQJZLWKWRROEDVH
%DVH OHQJWK
/HQJWK
%DVH OHQJWK
/HQJWK
GLPHQVLRQ
:LWKZLWKRXWPRQLWRU
LQJZLWKWRROEDVH
GLPHQVLRQ
Note
The cutting edge data for
D1 and D2 of a selected grinding tool can be chained, i.e. if a
parameter in
D1 or D2 is modified, then the same parameter in D1 or D2 is automatically
overwritten with the new value (see tool-specific data $TC_TPG2).