Spectracom SecureSync - Page 415

All outputs are listed, displaying their current output states. For a listing of the states, see
"CTCSS Outputs: Edit Window" below, and "Alarm Outputs: Edit Window" on page401.
To view the settings of one of the Alarm Outputs or CTCSS Outputs, go to its Status window. For
instructions, see: "Viewing Input/Output Configuration Settings" on page347.
The Web UI list entry for this card is named: Simulcast.
Note: Alarm Output 0 through Alarm Output 3 are reserved by SecureSync. Num-
bering for alarm outputs from the option card will begin at Alarm 4, which is
available on the DB-9 output, while Alarms 5 and 6 are assigned to the RJ-12 con-
nector.
Figure 5-34: Simulcast Alarm Output Status window
CTCSS Outputs: Edit Window
To configure a CTCSS output, go to its Edit window. For instructions, see: "Configuring Option
Card Inputs/Outputs" on page348.
The Web UI list entry for this card is named: Simulcast.
SecureSync User Reference Guide 399
APPENDIX