Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 147
Chapter 3
TimeProvider 5000 CLI Command Set
show input-config
This command displays the input port's state, priority, framing type, CRC, SSM
state, SSM Bit, user-assigned SSM PQL value and whether the configuration
settings for the port are used. The settings will not be used if the port is configured
as an output..
Command Syntax:
show input-config
Example:
tp5000> show input-config
Response:
------------------------------------------------------------------------------
|Port ID| State |Prio|Frame Type |CRC St |SSM St |SSM Bit|PQL Val|Config Used|
|-------|-------|----|-----------|-------|-------|-------|-------|-----------|
| port1 |disable| 1 |cas |disable|disable| 8 | 3 | no |
|.......|.......|....|...........|.......|.......|.......|.......|...........|
| port2 |disable| 2 |freq2048khz|disable|disable| 8 | 3 | yes |
|.......|.......|....|...........|.......|.......|.......|.......|...........|
Note: See 'show io-status' for current port status and
direction.
Level : User, Config, and Admin
set input
Use this command to provision the System's Input Port(s) for the following:
 Priority
 State
 Framing Type
 CRC state for E1 signals
 Forced PQL state for port
 PQL Bit position for E1/T1 signals
 Forced PQL-value (this value is used if SSM is disabled)
Note: Setting the Time of Day source to GPS with the set
tod-source
command will also set the input reference port state to
Disable.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English