148 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
Priority Quality Level (PQL) values are listed in the following table.
Command Syntax:
To set the priority for the specified input port:
set input priority port[1|2] [1-16]
To provision the state for the specified input port:
set input state port[1|2] [enable|disable]
To set the frame type for the specified input port:
set input frametype port[1|2]
[d4|esf|ccs|cas|freq2048khz|freq1544khz]
To provision the CRC state for the specified input port:
set input crc port[1|2] [enable|disable]
Quality Level DS1 SSM E1 SSM Description
1 0x04 0x02 Stratum 1/PRS/PRC
2 0x08 0x00 STU, Stratum Unknown (presumed ST1)
3 0x0C 0x04 Stratum 2/Type II
4 0x0C 0x04 Type I
5 0x78 0x04 Transit Node/Type V
6 0x7C 0x08 Type III/Stratum 3E
7 0x10 0x0B Type IV/Stratum 3
8 0x22 0x0F G.813OPT2/SMC
9 0x30 0x0F DUS, Do not Use for Sync
15 --- --- Did not receive valid SSM
Note: Setting the Time of Day source to GPS with the set
tod-source
command will also set the input reference port state to
Disable.
Note: The default input frame type is freq2048khz.
To Next Page
Loading...
Need help?
General
