Terex MHL360 E - Emergency Exit and Emergency Hammer; Fire Extinguisher (Optional); Preparations

5 OPERATION
5.2 MHL360 E
5.1.4 Emergency exit and emergency
hammer
The rear windshield acts as an emergency
exit. In case of an emergency:
►
If possible, move the loading machine into
the parking position and switch off.
►
Move the seat as far forward as possible.
►
Fold in the backrest.
►
Completely remove the rear windshield
with the emergency hammer (92/4).
►
Exit.
5.1.5 Fire extinguisher (optional)
ATTENTION
Note the manufacturer's information on the fire
extinguisher.
In case of an emergency:
►
Open holder (93/1).
►
Press in safety button (93/2).
► Press thrust button (933).
5.2 Preparations
Before operating the loading machine:
►
Inspect and secure the working area
around the machine.
►
Check to see whether loading machine and
tool are suitable for the intended work.
►
Check to see whether the position of the
loading machine relative to the material to
be loaded is favorable and whether the
ground is suitable as a support surface.
►
Check to see whether regeneration of the
diesel particle filter is possible at any time
at the current location. If the diesel engine
is started, pending regeneration occurs
even during idling.
h Chapter 5.6.1 Checking the diesel parti-
cle filter status
►
Open all hoods.
►
Perform checks.
h Care and maintenance chapter
1 2
BSB51180
3
4
Fig. 92 Emergency hammer/lamp glass
2
3
1
BSB51182
Fig. 93 Fire extinguisher
5.1.4
Emerge
ncy exit
and
emerge
ncy
hamme
r