Terex MHL360 E - Weekly Tasks

7 CARE AND MAINTENANCE
7.30 MHL360 E
7.6.3 Weekly tasks
Inspection and maintenance jobs to be performed by operating staff:
Item
Test method
Page No
1
Clean the cooling fins of the water/charge air cooler and hydraulic fluid cooler.
j If there is a heavy accumulation of dust, shorten the cleaning intervals. Otherwise
the result could be engine damage.
7.4.5
2
Check the coolant level and perform a visual inspection of the viewing glass as well
as a functional test of the air conditioning system.
8.8.1
3
Check the windscreen for proper functionality.
5.4.4
4 Check correct function of door latches —
5
Check the fastening of the wheel nuts.
7.4.6
6
Check the fastening of the slewing joint (hydraulic motor, transmission and slewing
ring)
7.7.16.1
7
Check the bushings and pins of the loading equipment
—
8
Check the hydraulic axle lock and vent the oscillating axle cylinders.
7.7.13
9
Condition and lubrication of angular resolvers (optional)
7.7.23
10
Check the pneumatic springs of the maintenance flaps on the windscreen to ensure
they are functioning properly.
—
11
Check function, condition and completeness of safety equipment.
—
12
Lubricate the machine according to overview of lubricating points
7.5
13 Check the grease container fill level 7.5.3
14
Opening the dust ejector valve on the air filter
7.7.4