Terex MHL360 E - Maintenance and Inspection Plan

CARE AND MAINTENANCE 7
MHL360 E 7.31
7.6.4 Maintenance and inspection plan
Work to be performed by trained dealer or service staff
Perform work with machine at operating temperature!
Item
Fuel supply and diesel engine (without exhaust system)
O = Check, carry out maintenance
x = Replace
after 500 hours
every 500 h
every 1000 h
every 2000 h
every 4,500 h
every 6000 h
Every 10000 hours
Per year
2 years
1
Engine oil
h Shorten intervals under difficult conditions.
X X
2
Engine oil filter (at each oil change)
X
X
3
Coolant (additive concentration)
O
X
4
Replacing the fuel pre-filter
X X
5
Replacing the fuel filter
X X
6
Flexible fuel lines (replace completely)
O
X
7 Drain water from fuel tank.
O
O
8 Check the air filter pipe.
O
O
9
Charge air cooler intake area (drain lubricating oil/condensate)
O
10
Air filter – replace main cartridge and safety cartridge
1)
h If there is a heavy accumulation of dust, shorten the cleaning
intervals.
X
X
11
Clean the cooling fins of the water/charge air cooler.
h Shorten intervals if there is a heavy accumulation of dust.
O O
12
Not used
O
O
13
Air conditioning compressor V-belt (tighten if necessary, replace if
damaged)
O
X
X
14
Main belt drive with tensioning pulley
O
X
X
15 Crankcase bleeder valve
X
16 Reed valve
X
17 Check valve lash on the drive engine (adjust if necessary, sooner if
there is noise)
O O
18
Engine bearer, mounting parts, hose connections, clamps (replace
when damaged)
O
O
19
Check battery and connection cables
O
O
20
Engine monitoring, warning system (only by service personnel au-
thorized by the engine manufacturer)
O
21
General overhaul
h The optimum point in time depends on the conditions of use on
site and should occur after consulting with the responsible
dealer.
O
7.6.4
Mainte
nance
and
inspecti
on plan