Terex MHL360 E - Supplementary Heating (Optional)

OPERATION 5
MHL360 E 5.25
5.8.5 Supplementary heating (optional)
The supplementary heating (133/1) is located
on the left of the driver's cab. It heats the cab.
Any other use of the supplementary heating
and of the associated timer is not permitted.
The supplementary heating is connected di-
rectly to the fuel system, so that it can be op-
erated independently of the drive motor.
The supplementary heating is operated using
the operator device (132/32). Information
about the functions and the operation of the
supplementary heating can be found in the
operating instructions provided by the heater
manufacturer.
ATTENTION
The blower for the air conditioning system is
switched off automatically when the supplemen-
tary heating system is switched on. To prevent
heat accumulation, the ejector (132/20) cannot
be closed in a cab with supplementary heating.
ATTENTION
In the case of strong accumulation of dust,
change the air filter element every 100 operating
hours.
h Chapter 7.6.4 Maintenance and inspection
plan
j WARNING
Burns from igniting fuels, lubri-
cants and coolants
• The supplementary heating must
always be switched off when re-
fueling.
• Remove escaped fuel before
switching on.
In an emergency: Switch off ma-
chine and supplementary heating.
Administer first aid, seek treatment
from a doctor
j WARNING
Poisoning and suffocation from
exhaust gases
• The heater must not be operated
in enclosed spaces.
In an emergency: Switch heating
off. Move into fresh air immediately.
Seek treatment from a doctor.
I
0
BSB50599
32
20
Fig. 132 Control panel for supplementary heating
1
BSB51201
Fig. 133 Supplementary heating
5.8.5
Supple
mentar
y
heating
(option
al)