Terex MHL360 E - Heating

5 OPERATION
5.22 MHL360 E
5.8.2 Heating
The cab heating is dependent upon the en-
gine coolant temperature.
Heating without reheat function
►
Switch off the air conditioning system with
the button toggle (129/83). The indicator on
the button toggle (127/83) must not light
up.
►
The button toggles (129/84) on the digital
display (129/85) can be used to adjust the
displayed temperature as required.
►
Adjust blower speed with the knob (129/80)
as needed.
►
The ejectors (127/18-21) can be used to
adjust the air distribution as required.
Heating with reheat function
The reheat function firstly cools the air and
then warms it. The ejected air is thereby drier
and does not steam up the windows.
►
Switch on the air conditioning system with
the button toggle (129/83). The indicator on
the button toggle (127/83) must light up.
►
Adjust the heating level, blower and air
distribution as described above.
Switching the heater controller off
►
The temperature indicated on the digital
display (129/85) should be lowered with the
minus button toggle (129/84) until the value
"lo" is displayed.
►
Lower again.
The controller is switched off.
Switching the heater controller on
►
The controller is switched back on with the
plus button toggle (129/84).
The digital display (129/85) indicates the
value "lo".
►
Set the desired temperature.
BSB50597
19
20
18
18
21
81
82
83
84
85
1
81
80
Fig. 129 Lever for heating/air conditioning system