Terex MHL360 E - Checking and Adjusting Valve Lash; Belt Drives

CARE AND MAINTENANCE 7
MHL360 E 7.51
7.7.6 Checking and adjusting valve lash
Valve lash must be tested according to the
operating instructions provided by the diesel
engine manufacturer, and adjusted if neces-
sary.
7.7.7 Belt drives
h Replace as described in chapter 7.6.4
Maintenance and inspection plan.
j WARNING
Danger of injury due to rotating
parts
• Belts should be checked and
tightened only when the diesel
engine is stopped.
• Secure the engine against being
started without authorization.
In an emergency: Administer first
aid, seek treatment from a doctor.
7.7.7.1 General
If a belts exhibits tears or if it is contaminated
with oil, coolant, grease etc., it must be re-
placed.
Perform check using the operating instruc-
tions of the diesel engine manufacturer.
ATTENTION
On belt drives with no tensioning pulley, use a
gauge to check the belt tension.