7 CARE AND MAINTENANCE
7.2 MHL360 E
7.1.2 Safe working positions
7.1.2.1 Maintenance position
►
Drive the machine to a suitable location
with even and solid ground. Take the
weather into account.
►
Slew uppercarriage into direction of travel.
If possible, move dipperstick into a steep
position.
►
If necessary, lay out plates on which to set
the grab tips so that the ground does not
get damaged.
►
Put the grab down on the ground in an
open position.
►
Retract the outrigger for the standard stabi-
lizer plate version, if using enlarged stabi-
lizer plates (optional), place them on the
ground.
►
Switch off and secure machine.
►
Place a sign in the cab informing that
maintenance work is being performed. En-
sure that no-one can enter the danger
zone.
7.1.2.2 Upper carriage
Danger of injury due to slipping
• Use only the access stairs and
platforms that have been provid-
ed.
In an emergency: Administer first
aid, seek treatment from a doctor
Routes and platforms are available in the up-
percarriage to reach the following mainte-
nance points:
Filler neck for diesel tank
Fuel filter, fuel pre-filter
Engine Oil Level
Engine oil filters
V-rib belt
Hydraulic oil level
Central lubrication system for uppercarriage
Batteries
Use the maintenance ladder to gain access.
h Chapter 5.3 Using climbing aids
Work platforms
►
A work platform or pedestal should be used
for work on the air filter, ventilation filter,
and return filter of the hydraulic system and
for filling hydraulic oil, coolant, and wiper
water. These must enable safe access and
prevent falling.
7.1.2.3 Undercarriage
Top
No maintenance points are provided on the
undercarriage.
Danger of injury due to slipping
• Do not climb on the top
In an emergency: Administer first
aid, seek treatment from a doctor
Bottom
The following maintenance points are on the
bottom:
Axles and transmission
Steer Cylinder
Serious injury due to sagging
machine
• Always retract outrigger
• Wear a hard hat
In an emergency: Administer first
aid, seek treatment from a doctor
To Next Page
Loading...
