Terex MHL360 E - Specifications for Fuels, Lubricants and Coolants

7 CARE AND MAINTENANCE
7.10 MHL360 E
7.3.2 Specifications for fuels, lubricants and coolants
Application
Designation
Recommended product
Specification, Standards, Quality
Engine
Diesel fuel
Use of branded fuels
DIN EN 590
ASTM D 975 S15
JIS K 2204: HFRR max. 460 µm
Before using RME fuels (rape oil
methyl ester), it is essential that
you consult your responsible
TEREX | Fuchs dealer for further
details.
h Engine manufacturer's operat-
ing instructions
Engine
Engine oil
Titan Cargo Maxx
SAE 10W-40
or
Titan Cargo Maxx
SAE 10W-40 XTL
≥ DQC III-10 LA
Only low-ash fuels approved by
the engine manufacturer may be
used.
h Engine manufacturer's operat-
ing instructions
Cooling system for
engine
Coolant mix-
ture
Clear, clean
water within
the following
analysis val-
ues
pH-value at 20°C
Chlorine (Cl)
Sulfate (SO
4
)
Water hardness (CaCo
3
)
6,5 - 8,5
max. 100 mg/l
max. 100 mg/l
max. 3.56 mmol/l
max. 20.0°dGH
h Engine manufacturer's operat-
ing instructions
Cooling sys-
tem protection
agent
MAINTAIN Fricofin Antifreeze with ethylene glycol-
based corrosion inhibitors
h Engine manufacturer's operat-
ing instructions
7.3.2
Specific
ations
for
fuels,
lubrican
ts and
coolant
s