Terex MHL360 E - Jobs before Putting the Machine into Operation; Checking the Engine Oil Level

7 CARE AND MAINTENANCE
7.14 MHL360 E
7.4 Jobs before putting the machine into
operation
►
Move the machine into the maintenance
position.
h Chapter 7.1.2.1 Maintenance position
j WARNING
Danger of injury due to uncon-
trolled machine movements
• Before putting the machine into
operation, the necessary safety
precautions must be observed.
In an emergency: Administer first
aid, seek treatment from a doctor
h Chapter 2.5.4 Putting the ma-
chine into operation safely
7.4.1 Checking the engine oil level
j
WARNING
Burns due to hot fluids and sur-
faces
• Engine oil is hot when the ma-
chine is at operating temperature.
• Avoid touching hot oil or parts
carrying oil.
In an emergency: Administer first
aid, seek treatment from a doctor
►
The oil level in the diesel engine must be
checked daily before starting work with the
machine in a horizontal position (with the
diesel engine turned off and after a short
wait so the oil can collect in the oil pan).
►
The oil must be between MIN and MAX on
the oil-level dip-stick (253/1).
►
If necessary, top up with oil until the level
reaches the upper mark MAX.
h Filling quantity, oil quantity and change
intervals:
Chapter 7.3 Fuels, lubricants and coolants
Chapter 7.6.4 Maintenance and inspection
plan
BSB50005
1
Fig. 253 Checking the engine oil level
7.4
Jobs
before
putting
the
machin
e into
operati
on