Toa VX-2000SF - Interrupt Broadcasts

Chapter 5: OPERATION
3. GENERAL-PURPOSE BROADCAST
5-30
3.4. Interrupt Broadcasts
Interrupt broadcasts can be activated from the control input or internal timer.
Preprogrammed interrupt broadcast patterns are recalled to make broadcasts during activation.
Notes
• To makethe Interrupt broadcast to a currently broadcast zone, the interrupt broadcast source should be
higher in priority than the current broadcast or should be assigned the LIFO priority if both broadcasts are the
same in priority level. For the priority settings, refer to
p. 7-30.
• Iftheassignedinputsources arethesame,broadcastsaremadetoeveryoutputzonesetinall recalled
patterns.
• Iftheassignedinputsourcesaredifferent, buttherecalledpatternoutputzones areduplicated,theinput
source assigned the highest priority is broadcast to all duplicated zones, while other recalled sources are
broadcast to the corresponding output zones that are not among the duplicated zones.
[Activation by means of the control inputs]
The Interrupt broadcast having its preset pattern overrides the current broadcast while the corresponding
control input is activated.
[Change by means of the internal timer]
The Interrupt broadcast having its preset pattern overrides the current broadcast during the duration from the
start time to the end time set by the internal timer.