Toa VX-2000SF - Rm-200 X Wall Mounting

Chapter 8: INSTALLATION AND SETTING PROCEDURES (HARDWARE)
1. RM-200XF AND RM-200X MICROPHONES
8-10
1.4. RM-200X Wall Mounting
[Necessary mounting hardware]
To mount the RM-200X to the wall, the following parts are required.
Wall mounting bracket for the RM-210 (model WB-RM200) ...... 1 (optional)
M3.5 screw for wiring box .......................................................... 2 (supplied with the WB-RM200)
Tapping screw for wooden wall .................................................. 2 (supplied with the WB-RM200)
Step 1. Attach the WB-RM200 Wall-Mounting Bracket to the wall.
In this case, leave the LINK cable out of the notch in the bracket.
• Installtheunitonlyinalocationthatcanstructurallysupporttheweightoftheunitandthemounting
bracket. Doing otherwise may result in the unit falling down and causing personal injury and/or
property damage.
• Besuretouse2screwswhenmountingthebrackettothewall.
Step 2. Hook the bottom surface of the RM-200X onto the WB-RM200.
Step 3. Plug the LINK cable into the RM-200X's LINK terminal.
Wall mounting bracket
WB-RM200 (optional)
RM-200X
LINK
Wall mounting screw
(supplied with the WB-RM200)
LINK cable
Notch
1
2
3
WARNING