Toa VX-2000SF - Installing the VX-200 SE in the VX-200 SZ and VX-200 SP

Chapter 8: INSTALLATION AND SETTING PROCEDURES (HARDWARE)
3. VX-2000SF, VX-200SZ , VX-200SP, VX-200SI , VX-200SO, AND VX-200SE
8-30
3.4. Installing the VX-200SE in the VX-200SZ and VX-200SP
• A 9-band, single-channel equaliser function can be added by installing the VX-200SE Equaliser Card in the
VX-200SZ Impedance Detection Module or the VX-200SP Pilot Tone Detection Module.
• In the PC software settings, "EQ" must be set to ON for the VX-200SZ and the VX-200SP in which the VX-
200SE is installed. For details, refer to
p. 7-14.
• Use the PC software to perform equaliser setting. For details, refer to
p. 7-37.
VX-200SP or VX-200SZ
VX-200SE