Toa VX-2000SF - Procedure to System Operation

Chapter 6: FROWCHART FROM SYSTEM SETUP TO OPERATION
1. PROCEDURE TO SYSTEM OPERATION
6-2
1. PROCEDURE TO SYSTEM OPERATION
System Setting File creation
(PC Software Offline)
Interrupt Broadcast Pattern
Setting Operation Mode
VX-2000 Properties Settings
VX-2000SF Properties Setting
Calculating Number of
VX-200PS units*
Calculating Battery Capacity*
Installing PC Software
Remote Microphone Properties
Settings
Emergency Broadcast Pattern
Control Output Interlock Pattern
EV Broadcast Pattern
Setting Activation Mode
Setting System Configuration
To the next page
(p. 7-5)
System Design
(p. 7-39)
Calculating Number of
VX-2000DS units*
(p. 7-5)
Volume Pattern
Failure Output Pattern
Remote Microphone Key
Assignment
Base Pattern
(p. 7-13)
EV Unit Settings
Battery Check Interval Setting
Monitor Interval Setting in AC
Failure
Setting System Mode
(p. 7-30)
Broadcast Priority Settings
Initial Volume Settings
Equaliser Settings
(p. 7-52)
Control Input Settings
Timer Settings
New File Creation
(p. 7-11)
* Refer to "Supplementary tools.xls" file
located in the "Supplementary tool"
folder on the CD-ROM accompanying
the VX-2000.