Toa VX-2000SF - Fifo;Lifo Priorities

Chapter 3: SYSTEM OPERATION OUTLINE
8. BROADCAST PRIORITIES
3-13
[LIFO broadcasts to the same zone]
While RM-3 is making broadcasts to Zones 1 and 2, if General EV1 of the same priority level makes broadcasts
to Zones 2 and 3, RM-3's broadcast to Zone 2 is interrupted, and General EV1 can make broadcasts to both
Zones 2 and 3.
RM-3
General EV 1
Zone 1
Zone 2
Zone 3
RM-3
General EV 1
Zone 1
Zone 2
Zone 3
8.2. FIFO/LIFO Priorities
Set FIFO (first-in-first-out) or LIFO (last-in-first-out) priority when 2 or more sources are identical in priority level.
This setting is possible for both Emergency RM and General categories.
FIFO: Priority is given to the first-enabled source. Other sources of the same priority level must wait until the
first-enabled source finishes its broadcast.
LIFO: Priority is given to the source last enabled. While one source is broadcasting, if another equipment
source makes a broadcast, the current broadcast is interrupted, allowing the broadcast of the latter
source to go through.
[FIFO broadcasts to the same zone]
While RM-3 is making broadcasts to Zones 1 and 2, if General EV1 of the same priority level makes broadcasts
to Zones 2 and 3, General EV1 is allowed to go through to Zone 3 but cannot broadcast to Zone 2 until RM-3
is finished.